ProAiir QuickEZ Lase sjabloon
€2.25
€4.50
€2.25
€4.50ProAiir QuickEZ Lase Stencil
The ProAiir QuickEZ Lase stencil puts a futuristic lase pattern on the skin in seconds. Press it down, airbrush or stamp with a makeup sponge or finger sponge, lift the stencil, done. The fastest route to a sci-fi or cyberpunk detail via airbrush or hand application.
What is the QuickEZ Lase stencil?
A reusable makeup stencil made from flexible, semi-transparent 7 mil mylar (approximately 0.18 mm thick).
The designs shown in product photos are examples; the colour that lands on the skin is entirely your choice with your makeup.
Size: approx. 11.4 x 14 cm, one design per stencil. The tab has a hole so you can hang the stencil on a key ring or stencil rack.
Why pick this stencil?
- Airbrush and hand application. Works with ProAiir Hybrid, ProAiir Ink, Endura and equally well with a sponge and water-activated face paint. You choose the technique that fits the job.
- Fast results. Press, spray or stamp, lift, done. Perfect when you need several sci-fi looks in a row at an event, cosplay day or on set.
- Reusable. Mylar is tough and flexible. Clean it properly and store it flat, and it will last you through many shows and shoots.
- Follows the contour of the body. The thin, flexible mylar sits flush against cheeks, forehead, décolletage or upper arms.
How to use the stencil
- Hold the stencil flat against the skin where you want the lase motif.
- Spray with the airbrush or dab with a damp makeup sponge.
- Lift the stencil straight up. Do not slide it across the skin or the lines will smear.
Tip for water-activated face paint: keep your sponge damp, not wet. Too much moisture and the paint seeps under the edges, leaving blurry lines.
Cleaning and storage
Rinse the stencil after use with lukewarm water and mild soap. Pat it dry gently and leave it flat until completely dry. Do not roll or fold it or the mylar will develop permanent creases.
Used ProAiir Hybrid? Rub the stencil first with a thin layer of mild soap, then rinse with lukewarm water. That pulls the alcohol-based makeup out of the mylar.
For storage: hang the stencil by the tab hole, or keep it flat between two sheets of paper inside a folder.
What can you use it for?
- Cyberpunk and sci-fi cosplay: Lase for futuristic character details
- Bodypaint: Lase as a tech layer in a robot, alien or cyber look
- Theatre and film: Lase for sci-fi characters and mecha effects
- Festivals and photoshoots: Lase as a geometric accent in an avant-garde look
- Workshops and demos: Lase to quickly lay down a recognisable techno pattern
Contents
1 reusable ProAiir QuickEZ Lase stencil in flexible mylar (7 mil), approx. 11.4 x 14 cm, single design.
Other QuickEz stencils
If this geometric-tech theme fits your work, have a look at these stencils from the same range:
- ProAiir QuickEZ Circle Group: circular motifs that pair well with tech and sci-fi looks.
- ProAiir QuickEZ Circuit Board: circuit board pattern for a convincing robot or cyborg effect.
- ProAiir QuickEZ Diamond Back: geometric diamond texture as an extra layer in an avant-garde or reptile look.
Browse the full ProAiir QuickEZ range with over 60 patterns and designs.
| Content: | - |
|---|---|
| Kind of product: | Face Paint Stencil |
Login
