ProAiir QuickEZ Circle Group sjabloon
€4.50
€4.50
ProAiir QuickEZ Circle Group Stencil
With the Circle Group stencil you lay down a sharp geometric techno pattern on skin in seconds. You choose the colour using your airbrush, a sponge or a finger sponge. It is the quickest route to a convincing cyberpunk or sci-fi effect.
What is the QuickEZ Circle Group stencil?
A reusable face and body paint stencil made from flexible, semi-transparent 7 mil mylar (approximately 0.18 mm thick).
The designs shown in product photos are examples. The colour that lands on skin is entirely your choice, based on the paint you use.
Size: approx. 11.4 x 14 cm, one design per stencil. The tab has a hole so you can hang the stencil on a keyring or stencil rack.
Why pick this stencil?
- Airbrush and manual. Works with ProAiir Hybrid, ProAiir Ink, Endura and just as well with a sponge and water-activated face paint. You pick the technique that suits the job.
- Fast results. Press, airbrush or dab, lift, done. Ideal when you need to apply a recognisable techno pattern to multiple people at a festival or workshop.
- Reusable. Mylar is tough and flexible. Clean it properly and store it flat, and it will last through many events and photoshoots.
- Follows the shape of the skin. The thin, pliable mylar sits snugly on cheeks, foreheads and collarbones alike.
How to use the stencil
- Hold the stencil flat against the skin where you want the Circle Group motif.
- Spray with the airbrush or dab with a damp make-up sponge.
- Lift the stencil straight up. Do not slide it across the skin or the edges will smear.
Tip for water-activated paint: keep your sponge damp, not wet. Too much moisture and the paint bleeds under the edges, making your lines soft and blurry.
Cleaning and storage
Rinse the stencil after use with lukewarm water and mild soap. Pat it dry gently and lay it flat until completely dry. Do not roll or fold it, or the mylar will develop permanent creases.
Used ProAiir Hybrid? First rub a thin layer of mild soap into the stencil, then rinse with lukewarm water. That lifts the alcohol-based colour out of the mylar.
For storage, hang the stencil by the tab hole or keep it between two sheets of paper in a flat folder.
What can you use it for?
- Cyberpunk and sci-fi cosplay: Circle Group for futuristic character details
- Bodypaint: Circle Group as a tech layer in a robot, alien or cyber look
- Theatre and film: Circle Group for sci-fi characters and mecha effects
- Festivals and photoshoots: Circle Group as a geometric accent in an avant-garde look
- Workshops and demos: Circle Group to quickly lay down a recognisable techno pattern
Contents
1 reusable ProAiir QuickEZ Circle Group stencil in flexible mylar (7 mil), approx. 11.4 x 14 cm, single design.
Other QuickEz stencils
Does this geometric tech theme fit your work? Have a look at these stencils from the same range:
- ProAiir QuickEZ Circuit Board: a network of circuit-board lines and nodes, ideal for robot and cyberpunk looks.
- ProAiir QuickEZ Diamond Back: a repeating diamond grid, clean and versatile for sci-fi and avant-garde applications.
- ProAiir QuickEZ Gears: a cog and gear motif that pairs perfectly with steampunk and mecha characters.
Browse the full ProAiir QuickEZ range with more than 60 patterns and designs.
| Content: | - |
|---|---|
| Kind of product: | Face Paint Stencil |
Login
