ProAiir QuickEZ Cracks sjabloon

ProAiir QuickEZ Cracks Stencil

With the QuickEZ Cracks stencil you add a crack pattern to a face, neck or arm in seconds. Press it down, airbrush or dab with a makeup sponge or finger sponge, lift the stencil off, done. The quickest route to a convincing horror or SFX look.

What is the QuickEZ Cracks stencil?

A reusable face paint stencil made from flexible, semi-transparent 7 mil mylar (approximately 0.18 mm thick).

The designs shown in product photos are examples; the colour that lands on the skin is entirely your choice of paint.

Size: approx. 11.4 x 14 cm, one design per stencil. The tab has a hole so you can hang the stencil on a key ring or stencil rack.

Why pick this stencil?

• Airbrush and hand application. The stencil works with ProAiir Hybrid, ProAiir Ink, Endura and also with a sponge and water-activated face paint. You pick the technique that suits the job.
• Fast results. Press, airbrush or dab, lift off, done. Perfect when you have a long queue of faces to do at a Halloween event or horror show.
• Reusable. Mylar is tough and flexible. Clean it properly and store it flat and it will last you many Halloweens.
• Follows the contours of the face. The mylar is thin and pliable, so it sits flush against a cheek, forehead or neck.

How to use the stencil

1. Hold the stencil flat against the skin where you want the crack pattern.
2. Spray with the airbrush or dab with a damp makeup sponge.
3. Lift the stencil straight up. Do not drag it across the skin or the edges will smear.

Tip for water-activated paint: keep your sponge damp, not wet. Too much moisture and the paint seeps under the edges, making your lines blurry.

Cleaning and storage

Rinse the stencil with lukewarm water and mild soap after use. Pat it dry gently and leave it lying flat until fully dry. Do not roll or fold it or the mylar will develop permanent creases.

Used ProAiir Hybrid? Rub the stencil with a thin layer of mild soap first, then rinse with lukewarm water. That loosens the alcohol paint from the mylar.

For storage: hang the stencil on the tab hole or keep it between two sheets of paper in a flat folder.

What can you use it for?

• Halloween makeup: Cracks on face, neck or arm for an atmospheric horror look
• SFX and cosplay: Cracks as a building block for zombie, vampire or grim-reaper characters
• Bodypaint: Cracks in a full body paint for Halloween parties or horror shows
• Theatre and film: Cracks for stage and camera work where speed matters
• Festivals and photoshoots: Cracks as a statement detail in a gothic or horror look

Contents

1 reusable ProAiir QuickEZ Cracks stencil in flexible mylar (7 mil), approx. 11.4 x 14 cm, single design.

Other QuickEz stencils

If this horror theme suits your work, have a look at these stencils from the same range:

• ProAiir QuickEZ Blood Cells: splattered blood cell pattern, ideal for horror and zombie looks.
• ProAiir QuickEZ Bloody Eyes: eye motif with blood effect, strong as an accent for SFX looks.
• ProAiir QuickEZ Centipedes: centipede motif for a creepy insect or creature look.

Browse the full ProAiir QuickEZ range with more than 60 patterns and designs.

The product photo shows an example face- or body-paint effect with this stencil. The Mylar stencil itself is semi-translucent; the final colour depends on the makeup or airbrush paint you choose.