ProAiir QuickEZ Bloody Eyes sjabloon

ProAiir QuickEZ Bloody Eyes Stencil

The QuickEZ Bloody Eyes stencil lets you place a bloodshot eyes motif on face, neck or arm in seconds. Press it flat, spray with an airbrush or dab with a makeup sponge or finger sponge, lift and you're done. It's the fastest route to a convincing horror look without hand-drawing every detail.

What is the QuickEZ Bloody Eyes stencil?

A reusable makeup stencil made from flexible, semi-transparent 7 mil mylar (approximately 0.18 mm thick).

The designs shown in product photos are examples; the colour that lands on skin is entirely your choice of makeup.

Size: approx. 11.4 x 14 cm, one design per stencil. The tab has a hole so you can hang the stencil on a keyring or stencil rack.

Why pick this stencil?

• Airbrush and hand application. Works with ProAiir Hybrid, ProAiir Ink, Endura and regular face paint with a sponge. You choose the technique that suits the job.
• Fast results. Press, spray or dab, lift, done. Perfect when you're working through a queue of faces at a Halloween event or horror show.
• Reusable. Mylar is tough and flexible. Clean it properly, store it flat, and it'll last many Halloweens.
• Follows the contours of the face. The thin, flexible mylar hugs the cheek, eye socket or forehead for clean, sharp edges.

How to use the stencil

1. Hold the stencil flat against the skin where you want the Bloody Eyes motif.
2. Spray with the airbrush or dab with a damp makeup sponge.
3. Lift the stencil straight up. Don't slide it across the skin or the edges will smear.

Tip for water-activated face paint: keep your sponge damp, not wet. Too much moisture and the paint seeps under the edges, giving you blurry lines.

Cleaning and storage

Rinse the stencil after use with lukewarm water and mild soap. Pat dry gently and leave it to dry flat. Don't roll or fold it, otherwise the mylar develops permanent creases.

Used ProAiir Hybrid? Rub a thin layer of mild soap into the stencil first, then rinse with lukewarm water. That breaks down the alcohol-based makeup from the mylar.

For storage: hang the stencil on the tab hole, or keep it flat between two sheets of paper in a folder.

What can you use it for?

• Halloween makeup: Bloody Eyes on face, neck or arm for an atmospheric horror look
• SFX and cosplay: Bloody Eyes as a building block for zombie, vampire or grim-reaper characters
• Bodypaint: Bloody Eyes in a full body paint for Halloween parties or horror shows
• Theatre and film: Bloody Eyes for stage and camera work where speed matters
• Festivals and photoshoots: Bloody Eyes as a statement detail in a gothic or horror look

Contents

1 reusable ProAiir QuickEZ Bloody Eyes stencil in flexible mylar (7 mil), approx. 11.4 x 14 cm, single design.

Other QuickEz stencils

If this horror theme fits your work, take a look at these stencils from the same range:

• ProAiir QuickEZ Blood Cells: blood cell pattern for an unsettling biological effect on skin or body.
• ProAiir QuickEZ Centipedes: centipede pattern for a crawling SFX look on arm or neck.
• ProAiir QuickEZ Cracks: cracked skin motif that pairs perfectly with zombie and creature looks.

Browse the full ProAiir QuickEZ range with more than 60 patterns and designs.

The product photo shows an example face- or body-paint effect with this stencil. The Mylar stencil itself is semi-translucent; the final colour depends on the makeup or airbrush paint you choose.