ProAiir QuickEZ Centipedes sjabloon
€2.25
€4.50
€2.25
€4.50ProAiir QuickEZ Centipedes Stencil
The ProAiir QuickEZ Centipedes stencil puts a crawling many-legged pattern on skin or body in seconds. Press it flat, airbrush or sponge over it with an airbrush, makeup sponge or finger sponge, lift it off and the look is done. The quickest route to a creepy horror effect on a busy night of faces.
What is the QuickEZ Centipedes stencil?
A reusable face paint stencil made from flexible, semi-transparent 7 mil mylar (approximately 0.18 mm thick).
The designs shown in product photos are examples; the colour that lands on skin is entirely your choice of makeup.
Size: approx. 11.4 x 14 cm, one design per stencil. The tab has a hole so you can hang the stencil on a keyring or stencil rack.
Why pick this stencil?
- Airbrush and hand application. Works with ProAiir Hybrid, ProAiir Ink, Endura and equally well with a sponge and water-activated face paint. You choose the technique that fits the job.
- Fast results. Press down, airbrush or stamp, lift the stencil, done. Ideal when you have a long queue of faces at a Halloween event or horror show.
- Reusable. Mylar is tough and flexible. Clean it properly and store it flat and it will last you many Halloweens.
- Conforms to body contours. The thin, flexible mylar hugs the cheek, neck, arm or décolleté cleanly.
How to use the stencil
- Hold the stencil flat against the skin where you want the centipedes motif.
- Spray with the airbrush or dab with a damp makeup sponge.
- Lift the stencil straight up. Do not slide it across the skin or the lines will smear.
Tip for water-activated face paint: keep your sponge damp, not wet. Too much moisture and the paint bleeds under the edges, leaving fuzzy lines.
Cleaning and storage
Rinse the stencil after use with lukewarm water and mild soap. Pat it gently dry and leave it flat until fully dry. Do not roll or fold it or the mylar will develop permanent creases.
Used ProAiir Hybrid? Rub the stencil with a thin layer of mild soap first, then rinse with lukewarm water. That releases the alcohol-based colour from the mylar.
For storage: hang the stencil by the tab hole, or keep it between two sheets of paper in a flat folder.
What can you use it for?
- Halloween makeup: Centipedes on face, neck or arm for an atmospheric horror look.
- SFX and cosplay: Centipedes as a building block for zombie, vampire or grim-reaper characters.
- Bodypaint: Centipedes in a full body paint for Halloween parties or horror shows.
- Theatre and film: Centipedes for stage and camera work where speed matters.
- Festivals and photoshoots: Centipedes as a statement detail in a gothic or horror look.
Contents
1 reusable ProAiir QuickEZ Centipedes stencil in flexible mylar (7 mil), approx. 11.4 x 14 cm, single design.
Other QuickEz stencils
If this horror theme fits your work, have a look at these stencils from the same range:
- ProAiir QuickEZ Blood Cells: blood cell pattern for realistic SFX looks on skin and body.
- ProAiir QuickEZ Bloody Eyes: bloodshot eye motif for zombie and horror characters.
- ProAiir QuickEZ Cracks: cracked skin pattern for broken skin, statues or earthquake SFX.
Browse the full ProAiir QuickEZ range with more than 60 patterns and designs.
| Content: | - |
|---|---|
| Kind of product: | Face Paint Stencil |
Login
